Cool. It's always nice to learn something new.
So I edited my NAT Port Forwarding settings for both the servers to include the "pass" setting for 'Add associated filter rule' and I tried with and without my FW rule for allowing traffic to pass on ports 25565 - 25566 on the WAN interface, but I still can't connect to the servers from outside of my LAN. I only have one WAN interface, so as you said nothing showed up under the FW rules, but the icons changed from > to <->
I try scanning the ports with this tool: https://www.ipfingerprints.com/portscan.php but they're both "filtered"
There must be something really obvious that I'm doing wrong here. How hard could it be to get this configured right... Anyway. I'm about to set up a new computer for OPNsense, so I'll do a fresh install, just to start from scratch and then see if I can get this working. I'll report back whether I get it working or not.
So I edited my NAT Port Forwarding settings for both the servers to include the "pass" setting for 'Add associated filter rule' and I tried with and without my FW rule for allowing traffic to pass on ports 25565 - 25566 on the WAN interface, but I still can't connect to the servers from outside of my LAN. I only have one WAN interface, so as you said nothing showed up under the FW rules, but the icons changed from > to <->
I try scanning the ports with this tool: https://www.ipfingerprints.com/portscan.php but they're both "filtered"
There must be something really obvious that I'm doing wrong here. How hard could it be to get this configured right... Anyway. I'm about to set up a new computer for OPNsense, so I'll do a fresh install, just to start from scratch and then see if I can get this working. I'll report back whether I get it working or not.